Introduction

Hello Guys I am RAJ KAMAL . To day i will tell you how to hacker attack on wireless network. Wireless networks are a quick and easy way to connect devices at work or home. Users can plug in Connect the wireless router (or use the provided wireless modem) to their ISP’s modem and all their devices. This article shows how to attack the WPA-2 PSK (Pre Shared Key) network that is used by most consumers.

Hacking tool Installation

On Debian (Kali linux, ubuntu etc.)   based versions of Linux you can use the apt command to install aircrack-ng.

$ sudo apt install aircrack-ng

Wireless Card Modes

Wireless protocols use multiple frequency bands within the wireless spectrum for sending data. The frequency used by
802.11 is 2.4 GHz and 5 GHz, each of which are unlicensed and available to be utilized by consumers. Wireless cards
have the ability to receive and decode wireless signals on the LAN that are destined for both it and other wireless
devices in the area. This is the nature of Ethernet networks as well as the physics of how wireless signals propagate. To
sniff data on your network that are not destined for your wireless device, you must have a wireless card that can enter
monitor mode. This will involve root or Administrator access to the device and normal programs will not be able to
access the Internet.

Enable Monitor Mode

$ sudo airmon-ng
PHY Interface Driver Chipset
phy0 wlan0 iwlwifi Intel Corporation Wireless 8265 / 8275 (rev 78)
$ sudo airmon-ng start wlan0

If your card is being used by the operating system, you may have to run the check kill command with airmon-ng. You Can also Use ifconfig command to view  your wireless card.

 $ ifconfig

Found 5 processes that could cause trouble.If airodump-ng, aireplay-ng or airtun-ng stops working after a short period
of time, you may want to run ‘airmon-ng check kill’.

Leave a Comment